...
- Each Mode has preset measuring times but these are changeable. To access the Measurement Time click on the Setup Button at the top of the screen (Figure 6). Then in Left Panel click on Test Condition. This brings up a screen that shows the Minimum and Maximum time currently set for each beam. Adjust the settings to your liking and click Save.
...
- Note: In exp. 392 the "Test End" was set to LiveTime after having some issues with exporting spectrum files. For further notes please see pXRF user guide.
Figure 6. Test Condition Window. A. 'Setup' Button on the top right of the screen. B. 'Test Condition' Option in the Left Panel. C. Minimum and Maximum Time Settings for each beam. D. LiveTime is the preferred Test End time. E. 'Save Button
Note: If the minimum time is set to 1 and the maximum to 30, if the gun determines it has a good profile in less than 30 seconds it will stop actively measuring. If you want to ensure it measures for the full time, set the minimum and maximum time to the same number.
...