Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Core Catcher Procedure

Removing the core catcher material is generally done by a designated technician. Every core recovered has a core catcher at the bottom of the core barrel. The core catcher is removed on the rig floor and passed to the designated technician. The technician must extrude all core material from the core catcher and placed in a core liner (guidelines and rules listed below). That 'Section' of core is called the CC (core catcher).
Below are a series of steps to help guide you through the Core Catcher (CC) procedure.

...

PPE may include: apron or rain coat.

Arbor Press


If the Core Catcher material is difficult to manually push out from the core catcher, use the Arbor Press (see Figure 4 and Figure 5). There is a jig that can be used to assist with the pushing either APC and one for XCB ((Figure 6). Lubricate the moving parts of the arbor press with Lubriplate, or a mixture of Lubriplate and Marvel Mystery Oil. 

...

Figure 7: Toothed Square Rod, Proper Configuration


XCB Core Catcher   Image Modified


Use a strap wrench to remove the XCB cutting shoe.  Take the cutting shoe to the press and place it top side down in the APC jig on the press.  Press out the material (this may be hard, it gets baked in sometimes).

...