Temperature Controller Settings
- jr_novak
Temperature Controller settings as of Exp 391. See the DTB Series manual or the SOLO 4848 manual for more information on how to setup the controller.
Temperature Controller Settings-SHIL | ||
|---|---|---|
Operation Mode | ||
Code | Meaning | Selection |
r-s | (run or stop) | RUN |
SP | decimal point position | 1 |
AL 1H | Upper limit alarm | 50 |
LOC | setting lock mode | off |
out 1 | display and adjust output value of 1st output group | 0 |
Out 2 | display and adjust output value of 2nd output group | 0 |
 |  |  |
Regulation Mode | ||
At | auto tuning | off |
Pcd0 | PID Control setup - set which group to save parameters to | 39 |
Pcd1 | Â | 0 |
Pcd2 | Â | 0 |
Pcd3 | Â | 0 |
Pcd4 | Â | Auto |
Su0 | PID setting N=0 | 39 |
P0 | Proportion band setting N=0 | 30 |
C0 | Ti setting: n=0 | 65 |
d0 | Td setting: n=0 | 63 |
Cof0 | Integral deviation setting: n=0 | 0 |
HtPd | Heating/cooling control cycle setting | 30 |
HCPd | Control cycle setting of 2nd output group | 5 |
CoEF | P value of 1st and 2nd output group during dual loop output control | 0.1 |
Dead | deadband | -1 |
tPof | regulate temperature deviation value | 0 |
 |  |  |
Initial Setting Mode | ||
CnPt | Set Input type | K |
tPun | Set temperature unit | C |
tP-H | set upper limit of temperature range | 999.9 |
tP-L | set lower limit of temperature range | -199.9 |
Ctrl | Set control mode | PCd |
S-HC | Select heating/cooling or dual output control | H1C2 |
ALA1 | Alarm 1 mode setting | 6 |
ALA2Â | alarm 2 mode setting | 0 |
SALA | set system alarm | Off |
CoSH | Communication write function enable/disable | On |
C-SL | ASCII, RTU Communication formats selection | ASCII |
C-no | Communication address setting | 1 |
bPS | communication baud rate setting | 9600 |
Len | Data length setting | 7 |
Prty | parity bit setting | Even |
Stop | stop bit setting | 1 |
Â